G27 wheel

[kenny_ascar]

Hi!

Just got one yesterday. And started to get use to it, have got it ok setup for NR2003 and Simbins Race injection I think. But feels like it's glapping, have no resistance when I turn it for the first few degrees both ways, left right, this makes it hard to keep the car in a straight line and especially in the break zone after a long straigth. Is it broken, so I should go and replace it??

Thanks for any help

 

[gojimmie]

It should work fine.Try these settings inside of control panel,under game controlers.(Degree of Rotation 415%)(FF Settings,(Overall 125%,Spring 100%,Damper 125%)(Center Spring Strength 150%)Then,under Logitech Profiler,(Sensitvity 75%)(Dead Zone 0%)(Range 100%).Hope this helps.(y)

 

[kenny_ascar]

Hi! Thanks now it works nice for NR2003, it's fun to drive again.

But for Simbin game it does not do any difference, still got a bit of deadzone. When I'm inside game control panel and adjusted as you said I still have no resistance in the wheel for the first 3-5degrees when turning the wheel. Makes me not knowing how much I actually turn my wheel before the resistance kicks in after 5degrees or so.
Difficult to know how it should fell since it's my first wheel. And it sounds funny as well.

 

[gojimmie]

Glad to hear it's workin for yeah.It took me awhile to figure it out to.Yeah know,Google is great for getting info on the G27 to.Don't forget about the in game adjustments to.I know it's a self calibrating wheel,but i also calibrate it in game everytime I race.I can post my in game settings if you need um.Just let me know.

 

[sness48]

i would like to see your in game settings. i tried the others and it was nice. thank you. stacey

 

[gojimmie]

FF 71%,Damping 60%,Latency 150ms.Under Advanced Tab,Steering Assist 25%.Non-Linear 100%.Everything else 0%.All I have is Stability Control checked off.Hope this helps.